Automatic ultrasonic cleaning machine generally has timing or heating function, we introduced several common timing configuration of th series ultrasonic cleaning machine, today we will introduce several common heating configuration, hope to let you have a better understanding of ultrasonic cleaning machine through this article.

1、數控面板加熱

1. Numerical control panel heating

一般實驗室用的數控超聲波清洗機，帶有加熱功能的機型，如th-300bq，就是數控按鍵加熱。數控區顯示當前溫度，可以設定溫度值，當達到加熱值是自動停止加熱。此種加熱一般是用硅膠板加熱。

The general laboratory used numerical control ultrasonic cleaning machine, with heating function, such as th-300bq, is the numerical control key heating. The current temperature is displayed in the numerical control area, and the temperature value can be set. When the heating value is reached, the heating will be stopped automatically. This kind of heating is generally with silica gel plate heating.
           

2、溫控儀加熱

2. Temperature controller heating

分體超聲波清洗機根據使用情況有用溫控儀加熱，使用方法如下：按下加熱開關，溫控儀將顯示測量溫度與控制溫度。上面顯示的是測量溫度，下面顯示的是控制溫度，當測量溫度低于控制溫度時，溫控儀上out燈亮，加熱指示燈亮，設備處于加熱狀態;當測量溫度高于控制溫度時，溫控儀上out燈滅，加熱指示燈熄滅，設備停止加熱?？刂茰囟仍O(shè)置方法：按撥碼鍵設定控制溫度，如058，控制溫度為58度。此種一般是用加熱管加熱。

Separate ultrasonic cleaning machine according to the use of useful temperature controller heating, use the following: press the heating switch, temperature controller will display the measured temperature and control temperature. When the measured temperature is lower than the control temperature, the out light on the temperature controller is on, the heating indicator is on, and the equipment is in the heating state; When the measured temperature is higher than the control temperature, the out light on the temperature controller goes out, the heating indicator goes out, and the equipment stops heating. Control temperature setting method: press the dial key to set the control temperature, such as 058, the control temperature is 58 degrees. This kind of heating pipe is usually used for heating.

3、機械溫控

3. Mechanical temperature control

普通臺式超聲波清洗機一般用機械溫控，也就是旋鈕調節溫度，如th-500q型臺式超聲波清洗機，溫度調節范圍為常溫-80度。

Ordinary desktop ultrasonic cleaning machine generally uses mechanical temperature control, that is, knob to adjust the temperature, such as th-500q desktop ultrasonic cleaning machine, the temperature range is - 80 ℃.