1. Place the machine in a ventilated and dry area? Are there ventilation holes on both sides of the fuselage? Should it be cleaned regularly? So that the air can flow smoothly.

2.往清洗槽內注入清洗溶液、不能將過熱的清洗液驟然倒入清洗缸內、清洗溶液不能太少、不能在內槽無液體的狀態下開機、一般若不需加熱、液面大于內槽的1/3高度即可?若需加熱、液面高度應大于內槽的3/4高度。

2. Inject the cleaning solution into the cleaning tank. Do not suddenly pour the overheated cleaning solution into the cleaning cylinder. Do not start the machine when there is no liquid in the inner tank. Generally, if heating is not required and the liquid level is greater than 1 / 3 of the height of the inner tank? If heating is required, the liquid level shall be greater than 3 / 4 of the height of the inner tank.

3.將超聲波清洗機的三角電源插頭?插入帶有接地良好的單相220V±10%、50Hz交流電源插座上。

3. Connect the triangular power plug of the ultrasonic cleaning machine to the? Plug into a single-phase 220V ± 10%, 50Hz AC power socket with good grounding.

4.按動“超聲”按鍵?電源信號燈亮?此時槽內液體開始振動空化。若需要加熱則先選擇加熱溫度?室溫~80℃可調、通常加熱溫度為50℃?然后按動“加熱”按鍵,不要讓超聲波內槽溶液在80℃以上的溫度下、長期開機工作。

4. Press the "ultrasonic" button? Power signal light on? At this time, the liquid in the tank begins to vibrate and cavitate. If heating is required, select the heating temperature first? Room temperature ~ 80 ℃ adjustable, usually heating temperature is 50 ℃? Then press the "heating" button, and do not let the solution in the ultrasonic inner tank start up for a long time at a temperature above 80 ℃.

5.清洗完畢后?需把超聲波清洗機的電源關掉?然后才可放掉需更換的清洗液體。

5. After cleaning? Do you need to turn off the power of the ultrasonic cleaning machine? Then the cleaning liquid to be replaced can be discharged.

實驗室小型超聲波清洗機的主要用途：

Main uses of laboratory small ultrasonic cleaning machine:

用途：物件的清洗、PCB板的清洗、脫氣、消毒、乳化、混勻、置換、提取。

Usage: cleaning of objects, cleaning of PCB board, degassing, disinfection, emulsification, mixing, replacement and extraction.

應用行業：工礦企業，大專院校科研單位實驗室；醫院；電子車線；鐘表眼鏡店、珠寶首飾店；家庭。

Application Industry: Industrial and mining enterprises, universities, scientific research units and laboratories; hospital; Electronic vehicle line; Watch glasses shop, jewelry shop; family.

清洗物件：對附著在工件如電子產品、機械五金配件、眼鏡、首飾、鐘表、錢幣、水果等物件表面的污物進行有效的去除。

Cleaning objects: effectively remove the dirt attached to the surface of workpieces such as electronic products, mechanical hardware accessories, glasses, jewelry, clocks, coins, fruits and other objects.

以上就是工業超聲波清洗機給大家分享的主要內容，更多的精彩內容請大家繼續關注我們：http://www.slhysz.net

The above is the main content shared by the industrial ultrasonic cleaning machine. Please continue to pay attention to us for more wonderful contents: http://www.slhysz.net